Use a sharp drill bit that is designed for metal drilling.
How to drill out a bedroom door lock.
If the knob is to the right select a right handed door.
There are a variety of ways to install a lock on a door that don t require any drilling and many of them are simple and inexpensive.
Residential interior doors like those on bathrooms and bedrooms lock for privacy but aren t really made to be impassable.
Once you ve drilled through and broken the pins you may need to insert a flat screwdriver to retract the latch and open the door.
If you accidentally locked your bedroom door lock bathroom door lock or any other door in your house though a butter knife is certainly one of the best methods to open it without a locksmith.
These type of pins are made out of hardened steel so that they are harder than the drill bit.
Measure from the center of the door knob hole to the edge of the doorway to find the size of the door set.
Certain locks are not going to open as easily as others even with drilling.
Open the door and stand with your back to the hinges.
In most cases the door set which is inside of the door and controls the door latch.
If you re in a situation where you cannot or do not want to use a drill to install your lock there are a couple ways of installing an interior door lock without a drill.
Aim the drill into the area just above the keyway.
There is no point in drilling a lock that has anti drill pins.
Some blank doors have a specific swing direction.
Sharper knives are very dangerous when you re attempting to open a locked door because there s a possibility of you injuring yourself during the.
However many people can t drill into a door due to agreements with landlords lack of tools or door materials and door jamb layouts that make it difficult to install a traditional lock.
The goal is to drill through the pin tumblers not the keyway itself.
Understand the lock well enough to drill it properly.
Drill out the lock cylinder.
If the drill binds while drilling you may need to put the drill in reverse and pull it out of the lock to draw out excess metal filings created by drilling through metal.
The non locking side of the door should have a small hole likely on.
If the doorknob is on the left you need a left handed door.