How To Fix Hole In Wood Panel Wall

Be careful not to.

How to fix hole in wood panel wall.

Remove the wood moulding from the sides top and bottom of the damaged panel. Cut out a hole in 1 4 inch plywood or masonit adding about 1 2 inch or so on all sides. How to patch a hole in wood paneling step 1. A pry bar or screwdriver will work.

Use a utility knife to score an outline of the patch on the paneling surface. Measure the size of the defect in your project and add a little extra around it. Smooth the edges of the patch around the hole. Tip if you are having trouble getting the wall patch to stick try wetting it slightly with a wet sponge or a using a spray bottle filled with water.

To seal the seams between your patch and existing plywood use wood filler. Cut the panel out. Press a damp cloth over the scratched area of the panel. Then cut your patch and mount it to the spanning pieces.

Place the craft sticks on the back of the hole and secure them with wood glue. Take a utility knife and clean up the splinters on the edges. Scrape away loose debris from the hole. Be sure to use a large enough piece so that you can clamp this piece to the wood you want to work with and have enough room for the plunge router to move freely in the template.

Center the piece over the hole lining up grooves on the patch and paneling. Check the panel to see if the steam has raised the wood fibers you. If you re filling a hole in a cabinet wall or a wardrobe place the craft sticks on the inside of the hole. You should lay the craft sticks on the side they won t be seen from.

Place the glue around the border of the hole in your wood. When the great stuff was done. Apply the sticky side of the wall hole patch around the edges of the hole leaving at least a on each side of the hole. I would get a small can of great stuff and try to fill the hole with that to give it a good solid back.

How to patch wall paneling. Cut a piece of panel slightly larger than the hole or gouge. If the hole is only 6 wide a small piece of 2x4 or even 1x2 and a plywood patch will probably cover you. Cut some lumber to span the opening and attach it using screws through existing plywood around the opening.

Hold a hot steam iron against the damp cloth for about 30 seconds.