To create your hanger place the hook side of the tape onto the strip of wood on the wall.
How to hang a throw blanket on the wall.
Then i used a nail and hammer to add starter holes for some brass hooks.
Also on the backside top sew a strip of fabric to create a channel and hang with a rod.
The dowel will keep the blanket straight and level while the.
Use a hammer to drive a nail into each of the 4 corners of the blanket.
Hang the blanket with nails if you are planning to leave it up for a while.
It will hang best and be less distorted if you sew a backing material to it.
1 marked as helpful reply pam32823842.
I started by attaching 4 command velcro strips evenly spaced on the back of the board.
Wrap the blanket around the small canvas so the area you wish to display is centered on the canvas.
Use the loops to attach your cord or ribbon on either side.
Thread a wooden dowel with small metal loops on either end into the pocket.
For a larger canvas stitch the blanket onto the canvas near the perimeter of the blanket.
If the blanket is not too heavy hand sew a strip of velcro on the back along the hanging edge.
Be sure to sew the velcro in a straight line so that the blanket will hang properly.
The soft fuzzy strip goes fuzzy side up on the blanket.
Install a curtain rod at the top of your wall then fold the end of a blanket over a dowel rod and stitch it together on the back or create a rod.
Staple or tack the blanket along the back inside edge of the frame.
This arrangement is better because the loop side is softer making it easier to wash your blanket without having to remove the tape.
If the blanket is an heirloom or prized possession paint the wood strip first.
Hang the canvas on parallel nails attached to wall studs or wall anchors.
The seven foot boards are wider so i decided to use one of them to hang my throw on the wall.
Place the loop alongside the top edge of your blanket.
Staple or glue the other half of the velcro strip to a piece of wood.