How To Install Frp Panels Without Adhesive On Concrete Wall

Do not apply adhe sive to the wall only to the backside of the frp panels.

How to install frp panels without adhesive on concrete wall.

Use a trowel and apply a 1 4 inch thick layer of frp adhesive to the back side of the first panel. This allows moisture to penetrate the seams of the panels causing moisture damage. This adhesive is spreadable with a trowel and covers about 50 sq. Fiberlite frp panels may also be used as drop in ceiling panels.

A clean surface increases the bonding strength between the panels and wall. This liquid nails 1 gal. Fiberglass reinforced plastic panel adhesive is a high strength bonder specifically formulated for bonding frp panels but will also bond non fiberglass reinforced panels nrp. Voids between the frp and the wall surface cause the frp to release from the wall.

Apply the adhesive to 100 of the backside of the panel using a crosshatch pattern. Spacing all frp panels expand and contract due to changes in. Insert a tube of adhesive into a caulking gun then cut the tip off with a utility knife to make a 1 4 inch hole. Be sure to apply the adhesive all the way out to the edges of the panel.

Using the proper tools to install cut and drill the frp will keep the wall panels in place. Fiberglass reinforced panels or frp are thin flexible plastic panels made of strong polyester resin reinforced with fiberglass. Before you start your frp panels installation cut your corner moulding. They are used on walls and ceilings and can be installed directly over drywall wood concrete block and many other solid surfaces frp systems include plastic trim molding to create a continuous durable scratch resistant surface that is easy to clean and mold.

Following adhesive manufacturers application guidelines when choosing proper adhesives for the particular substrate you are bonding to is highly recommended. Cut it to fit the height of the wall apply a bead of silicone caulk down the entire length and press it into the inside corner. Slip the tongue and groove edges of the panels together and hold it or fasten it with two concrete nails. Squeeze the tube with the gun as you drag the tip along the back of the fiberglass.

Apply a layer of adhesive onto the back of the fiberglass sections with the caulking gun. Apply adhesive to the back side of the next panel and raise it against the wall. Apply the adhesive in rows that are 3 to 4 inches apart. Clips are recommended to.

Insert the panel into the corner moulding.