Use one roofing nail in each corner of the flashing to secure it to the roof.
Install a roof vent flashing.
Bend it back so that it overlaps the corner flashing.
It s soldered to a roof flange that layers into the shingles.
The traditional pipe flashing is a soldered lead riser pipe that encloses the vent pipe and folds in the pipe at the top.
Now that the old flashing is gone you can slide the new flashing over the pipe vent and maneuver it under the shingles above the pipe.
Next use a reciprocating saw with a rough in blade to cut the out the marked template.
Then set the piece down.
Pull the old flashing up over the vent pipe and scrape any old caulk and debris off the roof.
To install vent pipe flashing you will be placing the upper portion below the shingles while allowing the bottom portion that extends below the pipe to lay exposed on top of the shingles.
Be sure to like and subscribe in order to help me bring you more helpful videos filled with tips and tricks i ve learned over the years.
These need to be fabricated or ordered to match a specific roof pitch and pipe diameter.
Slip a flat bar under the edge of the vent flashing and pop the nails up photo 1.
Plenty more videos t.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Slide the new flashing over the vent pipe and under the shingles above the pipe.
Nail it in place with two nails one.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
After selecting an area to install from inside the building square the template between the roof rafters and outline with a marker.
If there is a split in the shingle along the edge of the flashing be sure to caulk the edge of the flashing.
In this video i cover installing a roof boot for a vent pipe in a metal roof.
Add a large bead of caulk in a half moon shape around the flashing and put the shingles back in place.
Using a sawzall cut any roofing nails in the area of the lower mounting plate flush with the sheathing.
Begin by removing the shingles at the affected area and removing old flashing if present.
Ensure it sits flat and extends at least 8 inches above the shingles.
Hammer one nail to the.
How to install step flashing with a wall corner step three.
Leave the bottom of flashing exposed so only the sides and top are covered by shingles.
Cut your shingles precisely to leave at least half an inch around the base.
